HOTA P6, Руководство по эксплуатации

Страница: 25 / 35

21
P6 Smart Charger
PWM Measurement
< Tools
PPM Out
Charger Settings > Tools
Operation and Setup
In the standby interface, long press the speed shuttle key to pop up the "Charger
Settings" menu,then choose the item “Tools” ; menu items are as follows:
Test parameters : PWM signal frequency ,duty cycle and pulse width
Regulate the parameters of the output signal, cycle and pulse width
of the
RF airplane control servo
Automatically regulate the parameters of the output signal, cycle and
pulse width of the RF airplane control servo
Control the RC airplane receiver’s PPM input signal ; change the signal
output of those eight channels
Back to the upper menu
PWM Measurement
Servo Manual Test
Servo Automatic Test
PPM Out
Back
Back
Servo Manual Test
Servo Automatic Test
The RC airplane control servo
signal analyzes the PWM
protocol, links to the signal
output of the RC receiver , and
the signal period and pulse width
of the PWM output are automat -
ically detected, then converted
into the steering output shaft
rotation angle value.
PWM Measurement
T 1 T 2
P W M M e a s u r e m e n t
1500us
15000us
T1
T2
66.6Hz
16500us
F
P
80% R
The RF airplane PWM protocol is
directly connected to the servo;
through setting the T1 ( cycle )
and the size of the pulse width, it
controls the angle of the swing
arm.
Servo Manual Test
S e r v o M a n u a l Te s t
20ms
T1
2200us P
The RF airplane PWM protocol is
directly connected to the servo;
through automatically setting
the T1 ( cycle ) and adjusting the
size of the pulse width , it
automatically controls the angle
of the swing arm.
Servo Automatic Test
S e r v o A u t o m a t i c Te s t
Low
Speed:
1000----2000uS
Range：
50Hz/20000uS Cycle:
1000
1000
1900
1500
1500
1800
1000
RF airplane receiver receives the
PPM protocol, through altering
signal cycles of those 8 channels,
it controls the signal output of
the receiver.
PPM Output
P P M O u t p u t
CH1:
CH2:
CH3:
CH4:
CH5:
CH6:
CH7:
CH8:
1500