HOTA P6, Руководство по эксплуатации

Страница: 21 / 35

17
P6 Smart Charger
172
mAh
23.33
V
Combined Charging...
CH1 00:00:52
3.886V
3.902V
1
4
3.885V
3.884V
2
5
3.891V
3.884V
3
6
21.2
W
500
A
LiPo-6S(4.20V) 55% 2
Operation and Setup
Working parameters Display
Combined Charging
Operation Time
Capacity
charged
Task Status
Output
Current
Total Battery
Voltage
Cell Voltage
Current channel
Combined Charging status: Simple Operation
1. Connec t power supply to the charger and wait for the system to complete its self-checking .
Connect the battery to the two output ports of the charger in the standby interface ;
2. After selecting corresponding channel , short press the speed shuttle key to pop up the
“Task Settings" menu, set the task to “Combined Charging" ; adjust the task parameters,
then short press the speed shuttle key to start the task ;
Scroll the speed shuttle key during operation can switch the display information in the lower half of the screen, which are cell
voltage , cell internal resistance and the operating data. The cell voltage can only be displayed in the mode of balance charging ;
cell internal resistance will only be displayed in the balance mode while measurement is valid ( not in precharged status and none
of the cells reaches fully charged status within 2 minutes ).
3. When the task of Regenerative Discharge is executing, short press the speed shuttle key
can pop up the "Adjust Task” menu to adjust the Regenerative Discharge current ; long
press the CH key can stop the current task.
4. Enjoy.
Battery parameters and
Percentage of completion
Output power