G.
G
G.
F
F
POWER
CONNECTION
You
Are
Here
Always unplug your Power Pack when not in use!
❶
Hand Controllers (2)
❷
Yellow Hand Controller Plugs
❸
Red Power Pack Plug
❹
Terminal Track
❺
Power Pack
❻
Wall Outlet
❼
Direction
of travel
a.
Plug the Power Pack into a convenient wall outlet.
b.
The cables for the Power Pack and the hand controllers
have color-coded plugs to help you make your connections
properly. First, plug the red plug into the red receptacle on
the terminal track. Next, plug the yellow hand controllers
into the yellow receptacles on the terminal track.
c.
To test track and power connections, hold a car on the
track with its metal contacts
touching the metal track rails.
Gently hold the front end of the car
down while lifting the vehicle as
shown (do not lift the vehicle by its
rear tires). Squeeze the hand con-
troller: the car’s rear tires should
spin. If they don’t, there’s a connection problem. Carefully
check the track and power connections.
d.
Your hand controller is your car’s “throttle.” The more
you squeeze the trigger the faster your car will go. Practice
at a slow speed for a few laps, until you’re ready to race!
3
4
1
2
5
6
A
7
A
SPECIAL NOTE TO ADULTS:
• Always make sure your Race Set is unplugged before
assembling or disassembling track. Always unplug
Power Pack when not in use. Regularly examine for
damage to the cord, plug, enclosure and other parts.
• In the event of any damage, this toy must not be used
with the transformer until the damage has been
repaired.
• Do not connect to more than the recommended num-
ber of power supplies.
• If this toy is being operated in the presence of chil-
dren under 8 years old, adult supervision is recom-
mended.
• This toy is not intended for children under 3 years old.
This toy must be used only with the recommended
transformer. The transformer is not a toy.
Now attach the terminal track section to the
corkscrew curve section, and set the assembled
track aside. Let’s go on to slalom section 1.
Once your race set is fully assembled, it’s time for some
power. Follow these steps for power connection.
To attach card-
board: carefully
remove card-
board piece #1
from sheet. Fold
in half to form an
arch, as shown.
Fold the two
“feet” as shown.
When properly
folded, they will
stand at a right
angle to the fold-
ed arch.
Attach two clips
to the sides of the
track as shown.
Set the two “feet”
into the clips to
attach the arch to
the track.
d
FOLD
B1964-0920G1 DAREDEVIL CHALLENG 2/21/03 9:55 AM Page 7
