6
VALLEY MODELS
4000, 6000, & PANELS WITH 3 SEC DELAY PCB.
WIRING INSTRUCTIONS FOR BASIC OPERATION
Typically all functions switches are off unless advanced features are needed. See function
switch setting on page 3 for details.
To supply the 120vac needed for the Hot Shot Transmitter to operate run a wire from
the pivot panels 120vac hot terminal on the fuse block to the 120vac Hot input on the transmit-
ter. Run another wire from the pivot panels neutral buss bar to the second 120vac Neutral input
on the transmitter.
With these models we recommend that you use terminal #3 and #4 on the 3 Sec Delay
PCB to control the Sensor on the Hot Shot Transmitter. Remove the wires that currently go in-
to them and cap them off. Run a wire from terminal #3 on the 3 Sec Delay PCB to the COM
input on the transmitter. Run a wire from terminal #4 on the 3 Sec Delay PCB to the ON
-
OFF
input on the transmitter. Connect a wire from the Lighting Ground terminal of the Hot Shot to
an NEC approved ground rod.
See diagram below
.
