7
3. Electrically Heated Condensate Pan
(if applicable)
The electrically heated condensate pan is used to evaporate condensate water from the
unit. To install the electrically heated condensate pan, follow the directions below.
WARNING
Verify that power to the unit is disconnected before installing pan.
1) Remove the panel that covers the recess
in the back of the unit. See Fig. 4.
2) Route the wire found in the recess in the
back of the unit through the wire cover
and install the wire cover to the unit.
3) Plug the cord (wire) routed in step 2 into
the female plug of the heated pan.
4) Replace the panel to cover the recess in
the back of the unit.
5) Clip the heated pan onto the mounting
plate and attach to the panel that covers
the recess in the back of the unit using
the 4 screws provided.
6) Install the plug cover to the rear of the
unit.
2. Overflow Pan
(if applicable)
Units are supplied with an energy efficient automatic condensate water evaporation
system. The overflow pan is supplied for the unlikely event that water cannot evaporate
at a high enough rate. If water is found in the overflow pan, call your Hoshizaki Certified
Service Representative for assistance. To install the overflow pan, follow the directions
below.
1) Attach the overflow pan's brackets by
engaging the tab on the bracket through
the hole in the bottom of the unit and
securing with the four mounting screws
provided. See Fig. 3.
2) Slide the plastic pan into place under the
vinyl hose on the back of the cabinet.
Cabinet
Overflow Bracket
Mounting Screws
Overflow Pan
Tab
Cover Panel
Heated Pan
Mounting
Plate
Plug
Plug Cover
Wire Cover
Wire
Cabinet
Fig. 3
Fig. 4
