Hoshizaki HFE-127B Series, Инструкция по эксплуатации

Страница: 19 / 24

ENGLISH
15
Fig. 11
Front Panel
Grip
The cabinet temperature is factory-adjusted to
3°C for the refrigerator and -18°C for the freezer. If
necessary, readjust the temperature as follows:
1) Open the front panel.
2) Press the set point button to display the current
set point temperature.
3) Press and hold the set point button, and push the
temperature control button until the temperature
display window shows the desired temperature.
The cabinet temperature is adjustable between
-0°C and 16°C (or -6°C and 12°C) for the
refrigerator and between -25°C and -7°C for the
freezer.
4) The displayed cabinet temperature is adjusted
to be almost equal to the temperature at the
center of the cabinet without foods. But it can be
different from the actual temperature depending
on arrangement of stored foods, frequency of door
opening or measuring points.
Fig. 12
Front Panel
Grip
2) The compressor and condenser fan motor will
start in 3 minutes.
2. FRONT PANEL
To open and close the front panel:
Pull each side of the front panel toward you to
release it from the grip on each side of the bottom,
and swing up the front panel as shown.
To close the front panel, fit both sides of the bottom
securely in the grips.
HRE, HFE
Set Point Button
Temperature
Display Window
Manual Defrost
Button
Reset Button
Temperature
Control Button
Frame Heater
Button
Set Point Button
Temperature
Display Window
Manual Defrost
Button
Reset Button
Temperature
Control Button
Frame Heater
Button
HRFE
Fig. 13
3. CABINET TEMPERATURE SETTING
IMPORTANT
1. Pressing the temperature control button
(downward) will not speed up refrigeration,
but will only lower the temperature setting.
2. The temperature range given below is only
the adjustable range. The actual cabinet
temperature depends on the ambient
temperature and other conditions.
To remove the front panel:
Release both sides of the bottom from the grips, and
lift it off vertically.