ENGLISH
13
Fig. 10
[1] Defrost Indicator Light
[2] Refrigeration Indicator Light
[3] Set Key
[4] Defrost/Reset Key
[5] Set Indicator Light
[6] Screen
[7] Down Key
[8] Up Key
Code
Function
Set Range Default Unit
F01 Menu password
00 to 99
55
NC
F02 Temperature setting
-2 to +12
1
°C
IMPORTANT
1. The temperature setting must be between -2
and 12°C to prevent possible failure.
2. To avoid the risk of failure, do not make
changes to other menus than “F02”.
3. T h e d i s p l a y e d c a b i n e t t e m p e r a t u r e
is adjusted to be almost equal to the
temperature at the center of the cabinet
without foods. But it can be different from
the actual temperature depending on
arrangement of stored foods, frequency of
door opening or measuring points.
Freezer
[8]
[7]
[6]
[2]
[3]
[4]
[1]
[5]
Operation Panel
Refrigerator
1) Open the window panel.
2) Press the set key for 3 seconds:
When the keypad password is set as “0”, the
set indicator light comes on and the screen
displays the “F01” menu. There is no password
authentication, so directly enter the menu mode to
set parameter.
When the keypad password is not set as “0”,
the set indicator light flashes and the screen
displays “00”. Press the up or down key to input
the password “55”. Press the set key to confirm
the password input. Then, the system enters the
menu setting item if the password is correct. If
the password is incorrect, the set indicator light
goes off and the system goes back to the normal
measuring and controlling status.
3) Temperature setting:
Press the up key. The set indicator light flashes
and the screen displays the set temperature.
Press the down key. The set indicator light flashes
and the screen displays the temperature of the
evaporator sensor.
After entering the menu setting items, press the
up or down key to choose the “F02” menu (see
note 2).
After choosing the “F02” menu, press the set key
to set parameter value. Press the up or down key
to adjust parameter value, and then repress the
set key to go back to the menu choosing status.
Under the setting status, press the defrost/reset
key or perform no operation for 30 seconds. The
system will save the parameters and exit from the
parameter setting mode.
Fig. 11
[1] Fan Indicator Light
[2] Set Indicator Light
[3] Refrigeration Indicator Light
[4] Defrost Indicator Light
[5] Defrost Key
[6] Down Key
[7] Up Key
[8] Set Key
1) Open the window panel.
2) Press the set key for 3 seconds:
When the screen displays “SEt”, press the set key
again to indicate the set temperature. Press the
up or down key to set the desired temperature
and press the set key. When the screen displays
“SEt”, press the set key again for 3 seconds or
perform no operation for 10 seconds. The system
will save the set temperature and indicate the
cabinet temperature on the screen.
Operation Panel
[3] [2] [1]
[4]
[8]
[7]
[6]
[5]
