4
ENGLISH
4) Remove the front panel (left) and top panel.
5) Remove the protective plastic film from the exterior. If the icemaker is
exposed to the sun or to heat, remove the film after the icemaker cools.
4. LOCATION
WARNING
This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing
equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
CAUTION
The location should provide a firm and level foundation for the icemaker.
NOTICE
Do not place anything on top of the icemaker or in front of the louver.
IMPORTANT
Normal operating ambient temperature should be within 5°C to 40°C. Water connection is
cold water only. Operation of the icemaker, for extended periods, outside of these normal
temperature ranges may affect production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or
service should they be required.
Top View
Side View
Rear
ICEMAKER
Front
Left
Right
Rear
Front
Top
ICEMAKER
15cm
15cm
15cm
15cm
15cm
In some high humidity environments, condensation may form inside the machine and drip onto
the floor. Do not install where the floor can be affected by water.
Avoid prolonged exposure of the appliance to direct sunlight.
5. INSTALLATION
CAUTION
Incorrect installation can cause harm to people, animals or other items, for which the
manufacturer cannot be held responsible.
1) Position the icemaker in the selected permanent site.
Top Panel:
Remove the screws and lift off.
Front Panel (Left): Remove the screws. Lift up
and pull toward you.
Top Panel
Front Panel
(Left)
