Hoshizaki AM-50BAJ, Инструкция по эксплуатации

Страница: 30 / 41

30
4) Move the control switch to the "ICE" position and allow the icemaker to operate for
2 minutes. This allows the water tank to fill.
5) Move the control switch to the "OFF" position.
6) Inside the ice storage bin, disconnect the suction tube by squeezing the tabs and
pulling the tube clear. See Fig. 32. Allow the water tank to drain.
7) Reconnect the suction tube as illustrated. See Fig. 33. Make sure the tabs lock into
place; a loose fitting may cause a water leak.
8) Clean the ice storage bin liner, door liner, and door gasket using a neutral cleaner.
Rinse thoroughly after cleaning.
9) Move the control switch to the "ICE" position to start the automatic icemaking process.
10) To confirm bin control operation, hold ice in contact with the bin control thermostat
bulb.
NOTICE! If the icemaker does not stop within 10 seconds, the bin control
thermostat must be adjusted. Installation at higher altitude locations are more
likely to require adjustment. See Fig. 34.
Water Tank
Drain
Suction Tube
Tabs
Fig. 32 Fig. 33
Suction Tube
Tabs
Fig. 34
Bin Control
Thermostat