32
33
34
34a
30a
30b
31
35
Then the mesh can be cut straight down with a Stanley knife (photo 30a).Cut the bottom strip with the pair of scissors (photo 30b), like the strip on top.
(Make sure not to cut the cord.) Photo 31 shows the end result.
In order to slide the mesh in the base profile (and at a later stage in the corner piece) make an
incision (about 2 cm.) This incision has to be made in the outer pleat of the mesh (the first
pleat after the black strip) on both sides (photo’s 32 and 33).
Pull bar
Place the black strip, where you just made the incision, into the
upper chamber of the base profile and the rest of the mesh into the
chamber below (photo’s 34 and 34a ). Slide the base profile over
the mesh (photo 35).
Before you continue, repeat photo 13 till
35 for the blind.
