Hornby 'Elite" Unit, Руководство оператора

Страница: 22 / 27

RailCom ® is a registered trade mark of Lenz Systems.
1. Press Menu . Screen shows
“ Loco ”.
2. Rotate Control 1 until screen
shows “ Acc ”.
3. Press Control 1 . Screen shows
“ Direct ”.
4. Press Control 1 to confirm. Screen
shows “ Address ”.
5. Rotate Control 1 until screen
shows “ CV ”. Press Control 1 .
Screen shows “ CV Write ”.
6. Press Control 1 to confirm. Screen
shows “ CV 0001 W ”. 0001 is the
default setting.
7. Press Control 1 . Screen shows
“ CV 0001 W 000 ”. See Fig 1.
8. Rotate Control 1 until the CV
you wish to change is shown.
9. Press Control 1 . Rotate Control 1
to enter the new value for your
chosen CV. Press Control 1 to
confirm.
10. Press Control 1 . Red LED flashes
five times and screen shows
“ Address ”.
11. Press Menu to return to the main
screen.
Accessory Decoder Direct CV
Programming
Fig 1
41
For more information visit:
www.hornby.com
40
Step 2: Naming of the Accessory
Controlling Accessories
1. Press Acc . Screen shows the last
accessory operated.
2. Press Acc again if an alternative
accessory is required. Screen shows
“ Contr. :1 ” or “ 2 ” “ Adr:0003 ” or
the last accessory operated.
3. Rotate either Control 1 or 2 until
the number of the accessory/point
you wish to operate is shown. Press
the appropriate Control to confirm.
4. Press and release the selected
control knob. Accessory / point will
change direction together with the
arrow symbol on the screen.
Using the Elite it is possible to name all accessories / points that are digitally operated.
The Elite Control unit is capable of controlling 252 accessory/turnout addresses.
1. Press Menu and rotate Control 1
until screen shows “ Acc ”.
2. Press Control 1 to confirm. Screen
shows “ Direct ”.
3. Rotate Control 1 until screen
shows “ Features ” and press
Control 1 to confirm.
4. Screen shows “ Features
Adr:0000 ” and the number of the
last accessory used. Rotate
Control 1 to the accessory
number you wish to name and
press
Control 1 to confirm.
5. Screen shows “ Name _ ”. For this
example the name “ POINT 5 ” will
be used.
6. Press 7 twice. Screen shows “ P ”.
7. Press 6 four times. Screen shows
“ PO ”.
8. Press 4 four times. Screen shows
“ POI ”.
9. Press 6 three times. Screen shows
“ POIN ”.
10. Press 8 twice. Screen shows
“ POINT ”.
11. Press 0 twice. Screen shows
“ POINT ”.
12. Press 5 once. Screen shows
“ POINT 5 ”.
13. Press Control 1 to confirm.
Screen shows “ Direct ”.
14. Press Menu to return to the main
screen.
Please Note:
Should a mistake be made rotate
Control 1 anti-clockwise so that the
cursor moves back one position below
the incorrect letter. Press 0 twice and
the letter will disappear then continue
as above.
Elite HBook updated 6.3.07_Q6.qxd 13/3/07 13:09 Page 38