20
12. Do not place the device near an open window as rain could blow in; do not place on wet
surfaces and avoid any liquids being spilt nearby. Do not place the device behind a door
or along a walking route to avoid accidental trips.
13. The heater must not be located immediately below a socket outlet.
14. Do not use this heater in small rooms when they are occupied by persons not capable of
leaving the room on their own, unless constant supervision is provided.
Warnings
–
use
1.
Do not use additions/accessories on the device that have not been supplied or approved
by the manufacturer.
2.
Only use the device for its intended purpose and in the manner set out in this instruction
leaflet.
3.
Some parts of this product can become very hot and cause burns. Particular attention
has to be given where children and vulnerable people are present.
4.
Never cover or block the device; it will overheat and this could lead to a fire risk. Never
hang or place objects such as clothing, blankets, cushions, paper, etc. on the device. The
minimum distance of 1 meter between the device and flammable materials must always
be applied. Ventilation openings should never be blocked as this may pose a fire risk.
Never use the device to dry clothing or place anything on it. Do not let anything lean
against the device!
5.
Do not use this heater with a programmer, timer, separate remote-control system or any
other device that switches the heater on automatically, since a fire rest exists if the
heater is covered or positioned incorrectly.
Never use the device with an external voltage regulator such as a dimmer or similar, as
this could be dangerous!
6.
This device is exclusively intended to be used for heating workplaces such as workshops,
garages, storage spaces, etc. You must only use the device for this purpose.
7.
The connection voltage and frequency, as given on the device, must correspond to that
of the socket to be used. The electrical socket to be used must be an earthed
connection. The electrical installation must be protected via a 30 mA earth leakage
circuit breaker. The electrical socket that you are using must be to hand at all times in
order to be able to remove the plug from the socket in the event of an emergency.
8.
To avoid overloading and/or fuses being blown, do not use any other equipment on the
same socket or electrical group as the one used for the device.
9.
Unroll the electric cable for the device fully before inserting the plug into the socket and
ensure that the electrical cable does not come into contact with the fireplace or get hot.
Do not run the electrical cable under carpet, cover with mats, runners or similar and do
not place in areas that are walked on frequently. Ensure that it cannot be stepped on
and that no furniture is placed on top of it. Do not bend the electrical cable around sharp
corners and do not roll up too tightly after use! Prevent the electrical cable coming into
contact with oil, solvents and sharp objects. Check the cable and plug regularly for
damage. Do not bend or pinch the electrical cable and do not wind it around the device;
this could damage the insulation!
10.
The use of an extension cable is not advised as this can lead to overheating and fire. If
the use of an extension cable is unavoidable, make sure that it is not damaged and that it
is an approved extension cable with a minimum diameter of 4x2,5 mm² and a minimum
permitted capacity of 10000 Watt (Elektro-Heizlüfter 9000 Watt) und 16000 Watt
