Horizon Yacht Charters Bavaria 32 2012, Инструкция по эксплуатации и информации

Страница: 16 / 36

Setting a secondary anchor:
• Your secondary anchor is a quick set type of anchor and is usually stored in the cockpit
locker. It has 30 feet of chain and about 170 feet of line. For this reason we have always
found it easiest to put this chain in the dinghy with two people and deploy it from there.
Take note where your primary is and drive away from the yacht at a 45 degree angle of
the primary. Drop the anchor with the shank pointed at the yacht and deploy the rode as
you drive back to the bow of the yacht. Tie off at the bow. Once back on the yacht and
dinghy secured, manually take the slack out of the 2
nd
rode and tie off. Now engage
reverse to 1500 RPMs as before.
There is a high amperage fuse that will blow if the windlass gets overloaded
. The fuse is
located behind the 12V panel.
You can tell if the fuse is blown by the tab that pops up. Compare the fuse you have removed
with the one in the chart table. To replace, first turn windlass switch off on the 12v panel, pull
the blown fuse straight out and replace with the new one that is located in the chart table.
If you have any doubts or concerns, please call Horizon first. Before replacing the fuse,
however, ensure that the windlass switch on the 12v panel is switched on and run the engine
@1500 rpm for 15 min and try again. After replacing the fuse, if the windlass still refuses to
operate, please call horizon.