Horizon Reverse Osmosis Seafari Versatile Series, Руководство пользователя

Страница: 65 / 209

Seafari Versatile 450 - 1800
Page 5-3
5
5.2 INITIAL START-UP PROCEDURE
1. Ensure that all Tube Plugs and shipping caps
have been removed prior to commissioning.
Failure to remove these caps could cause
damage to the system.
2. Check the level of the oil in the High Pressure
Pump crankcase. Ensure that the oil level is
higher than the center of the sight glass.
Use only HRO supplied Pump Oil as it is
special hydraulic oil, which contains anti rust
and wear inhibitors essential to the high-
pressure pump crankcase section.
3. Check each tube connection at the side panel
of the System to ensure that the installer has
properly connected and properly routed each
tube. Improper routing and any blockage in
any line causes damage to the system. Do not
rely on the installers word, check it yourself.
4. Make sure that the Electrical Power Source to
the System is switched “OFF”.
5. Open the front panel of the Main Power
Enclosure. Check all connections for proper
wiring and attachment. Refer to the wiring
diagrams in Section 11 and 13.
6. Close the Main Power Enclosure front panel.
7. Ensure that the manual By-Pass lever on the
Diversion Valve [43] is positioned outward
(away from the coil body). The manual
bypass lever may be locked in the bypass
position by pressing it in fully and then
twisting 90° clockwise. To unlock, twist the
button 90° counter-clockwise. See fig 5a
below for location of the access hole to the
Diversion Valve [43].
8. Close the Commercial Pre-filter [14] drain
valve, if installed.
9. Close the Oil/Water Separator [17] Drain
Valve, if installed.
10. Close the air bleed valve located on top of the
Commercial Pre-filter [15], if installed.
11. Close the air bleed valve located on top of the
Oil/Water Separator [17], if installed. Open
the Inlet Sea Cock Valve [2] fully.
12. Position the Clean/Rinse Inlet Valve [4], if
installed, to the normal operating position
towards the Sea Strainer [3] Outlet.
13. Position the Clean/Rinse Outlet Valve [35],
if installed, to the normal operating position
towards the Brine Discharge Outlet [36].
14. Open any auxiliary Valve within the incoming
Feed Line; Outgoing Brine Discharge Line;
and Outgoing Product Water Line.
CAUTION
: Any auxiliary Valve in these
lines damages the Horizon Seafari if left
closed during starting and or operation of
the System.
15. Open the Back Pressure Regulator Valve [33]
FULL OPEN by turning counter clockwise.
CAUTION
: The Back Pressure Regulator
Valve [33] must be full open when
starting the Horizon Seafari System. If
this valve is left closed, it may cause
extensive damage to the system.
16. Switch the Electrical Power Source to the
Salinity Controller “ON”.
17. Electric Motor Rotational Check
Ask an assistant to view the fan section of the
Electric Motors, (High Pressure Pump Electric
Motor [25] and Booster Pump Electric Motor
[5]) while you Jog the System.
HP Pump Motor
Fan section (back view)
Booster Pump Motor
fan section (back view)
Diversion
Valve Manual
Bypass lever
Figure 5a: Remote Cube,
Diversion Valve location [43]