Horizon Reverse Osmosis Seafari Versatile Series, Руководство пользователя

Страница: 58 / 209

Seafari Versatile 450 - 1800
Page 4-18
4
3. Screw the fitting into cylinder ports to finger
tight position to achieve desired alignment.
4. Do not back-off fitting. Do not over-tighten
fitting. Over-tightening could strip the fitting
threads and cause a leak.
Install Quartz Sleeve
Perform this procedure only when water piping for
UV unit is in place and ready for service.
1. Visually inspect quartz sleeve for cracks and
damages.
2. Remove the
ballast box cover.
Remove the four
screws holding
the ballast box
cover then
remove the cover.
3. Remove the
rubber boot.
Pull out the
4-point lamp
connector.
4. Remove the compression nuts.
5. insert the quartz
sleeve. Place the
closed-end of the
quartz sleeve into
the cylinder through
the ballast box pass-
thru.
6. Leave a ½ in.
(12.7 mm) of the
quartz sleeve to
expose on the
viewport pass-
thru.
7. Lubricate the tips of the quartz sleeve with
clean water and insert new O-ring. Ensure
the O-ring has all-round contact with the
cylinder pass-thru.
4.5 UV STERILIZER INSTALLATION
The SP Series UV unit is shipped with the UV lamp,
quartz sleeve, fittings, and O-rings and need to be
assembled before the UV unit can be used.
1. Install the UV unit in a sheltered,
well ventilated area.
2. Install the UV unit as close as possible to the
point-of-use to avoid potential contamination
discharge from pipes, fittings, etc.
3. The UV unit should be mounted on stable
support to avoid straining or warping.
Allow sufficient clearance around the unit
for servicing.
4. Verify the location is free from vibration.
5. All UV units are rated for maximum operating
pressure at 50 psig (8.24 bar).
6. The UV unit must be properly grounded for
safe and proper operation. Failure to properly
ground the UV unit automatically voids all
unit warranty.
7. Line voltage must be within 10.56V to 16.50V.
Voltage outside the range will compromise the
performance of the UV unit.
Plumbing Requirements
All piping, tubes and hoses leading to the UV unit
connection points must be leak-free before the UV
unit can be installed.
NOTE ! The UV unit may be installed
horizontally or vertically. For vertical
installation, make sure the inlet port is
positioned at the bottom.
Installation Procedure
NOTE ! Do not assemble or install
damaged parts. Quartz sleeve and UV
lamp are fragile and must be handled
with care.
Install Fittings
Perform this procedure to prepare the UV unit for
installation.
1. Inspect each port and fitting to ensure threads
are free of dirt, burrs, and excessive nicks. If
threads are badly nicked, replace the fitting.
2. Wrap ¼ inch (6.35 mm) wide PTFE tape 2 to
3 turns counter-clockwise around the male
threads of the ¼ inch (6.35 mm) fitting.
DO NOT wrap tape around the first thread.