EN
5
Landing Gear Installation
1. Install the landing gear assembly (
A
) on the fuselage and secure in place
using 3 screws (
B
).
Disassemble in reverse order.
Model Assembly
A
A
B
C
Horizontal Stabilizer Installation
IMPORTANT:
The Ultimate 3D includes two tail tubes to accommodate the
use of a 3s or 4s battery. The lightweight composite tube is recommended
to achieve correct CG when using a 3S battery. The metal tube is
recommended to achieve correct CG when using a 4S battery.
1. Slide the horizontal tail tube (
A
) into the hole in the rear of the fuselage.
2. Install the 2 piece (left and right) horizontal tail as shown. Ensure the
control horn faces down.
3. Secure the 2 piece horizontal tail in place with 4 pieces tape (
B
) included.
4. Attach the ball link (
C
) to the elevator control horn’s outerermost hole using
the included nut and screw. Use a 4mm nut driver and 3mm hex wrench to
tighten the nut and screw.
5. Ensure the elevator and rudder servo arms are in the correct position, then
adjust the linkage to center them.
Disassemble in reverse order.
3 X 10mm (3)
B
2 X 10mm
2mm lock nut
