EN
5
To obtain the best flight performance, we recommend
using a DSM2
®
/DSMX
®
transmitter capable of Dual Rates.
Before binding, ensure that you are starting with a blank
acro model in your transmitter.
IMPORTANT:
After you set up your model, always rebind
the transmitter and receiver to set the desired failsafe
positions.
Program Your Transmitter
1. Start with a new ACRO Model.
2. Set Aircraft Type : Wing >1Ail 1Flap
: Tail > Normal
3. Leave all settings at their default values.
The Gear Switch (Ch 5) will control the SAFE mode func-
tion.
• Switch position 0 = SAFE Mode
• Switch position 1 = AS3X Mode
Transmitter Setup
Dual Rates and Expos
The suggested settings shown here are the recommended
starting settings. Adjust according to the individual prefer-
ences after the initial flight.
NOTICE: Do not set your transmitter travel adjust
over 100%.
If the TRAVEL ADJUST is set over 100%,
it will not result in more control movement, it will
overdrive the servo and cause damage.
It is normal for linear servos to make significant noise. The
noise is not an indication of a faulty servo.
TIP:
For the first flight, fly the model in low rate.
TIP:
When not using the flaperon function, only fly in flap
position 0, as Positions 1 and 2 will affect elevator trim.
Telemetry Alarms
Rx V : Min Rx V
4.2V
Smart ESC : Low Voltage Alarm
3.4V
Smart Battery : Startup Volt Minimum
4.0V
Computerized Transmitter Setup
DX Series, NX Series, iX Series
Start all transmitter programming with a blank ACRO
model (perform a model reset), then name the model.
Reversing
All Normal
Dual Rates
HIGH 100%
LOW 70%
Exponential (High Rate) 10% on aileron, elevator and
rudder
Servo Travel
100%
Timer
5 minutes
Set Throttle Cut to:
-100%
