EN
UMX Timber X BNF
12
Float Installation (Optional)
Landing Gear Removal
1. Carefully invert the aircraft. Do not put pressure on the
rudder.
2. Use a Phillips screwdriver to remove the four 2mm x
8mm self tapping screws and 2 plates securing the
landing gear.
3. Remove the other four 2mm x 8mm self tapping screws
and 2 plates for the rear float mount. Save all screws
and plates for the float installlation.
4. Remove the landing gear.
Float Installation
1. Install the included rear float wire onto the floats.
2. Install the floats as shown.
3. Install the 6 screws and 4 plates removed above.
