EN
Program your transmitter to set the rates and control throws based on your
experience level.
After flying, you may choose to adjust the values for the desired control response.
Horns
Arms
Aileron
Elevator
Rudder
Flaps
The table to the right shows the factory settings for the control horns and servo arms.
These settings, in conjunction with the low rate transmitter settings, are intended for
intermediate level pilots to help ensure a successful flight.
Fly the aircraft at these factory settings before making changes.
Nose
Wheel
10
Twin Otter 1.2m
Control Surface Direction
Power on the transmitter and connect the battery. Use the transmitter to
operate the aileron and elevator controls. View the aircraft from the rear when
checking the control directions.
Ailerons
1. Move the aileron stick to the left. The right aileron should move down and
the left aileron up, which will cause the aircraft to bank left.
2. Move the aileron stick to the right. The right aileron should move up and
the left aileron down, which will cause the aircraft to bank right.
Aileron stick
Rudder stick
Elevator stick
Elevators
1. Pull the elevator stick back. The elevators should move up, which will
cause the aircraft to pitch up.
2. Push the elevator stick forward. The elevators should move down, which
will cause the aircraft to pitch down.
Rudder
1. Move the rudder stick to the left. The rudder should move to the left,
which will cause the aircraft to yaw left.
2. Move the rudder stick to the right. The rudder should move to the right,
which will cause the aircraft to yaw right.
Dual Rates and Control Throws
Low Rate
High Rate
Aileron
8mm
12mm
Elevator
8mm
12mm
Rudder
10mm
20mm
Flap Travel
Half
q
= 10mm
Full
q
= 20mm
