EN
5
The SAFE Select switch must be assigned to the Flap switch (switch D) BEFORE
proceeding to the Transmitter Setup and should start from a blank (reset) model.
Failure to assign the SAFE switch prior to programming the other model functions
may prevent the SAFE switch from assigning correctly. Users of the DX6 and DX6e
will have the SAFE Select functionality linked to the fl aps. The values given in the
Transmitter Setup table turn SAFE on when the speed brake is fully deployed. SAFE
is off when the speed brake is not fully deployed.
IMPORTANT:
When programming the Flap System function in the transmitter
setup of the DX6 and DX6e, set the Speed value to Norm. Adding any delay to the
deployment of the fl aps will also delay the activation of SAFE.
DX6 and DX6e Transmitter Setup for SAFE® Select Operation
Start all transmitter programming with a blank ACRO model (do a model reset),
then name the model.
Set Dual Rates to:
HIGH 100%
LOW 70%
Set Servo Travel to:
100%
DX6e
DX6
(Gen2)
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set AIRCRAFT TYPE:
WING: 1 AIL 1 FLAP
4. Go to the FUNCTION LIST
5. Set SERVO SETUP: Reverse Flap
See the SAFE
®
Select Switch Designation section BEFORE setting the
fl ap values.
6. Set FLAP SYSTEM:
SELECT SWITCH D:
POS 0: 100% FLAP*
POS 1: 0% FLAP*
POS 2: -100% FLAP*
Canopy Installation
1. Slide the front of canopy into the canopy pocket.
2. Press the backside of the canopy down until it clicks into place.
Vertical Fin Installation
1. Connect the rudder servo connector to the extension in the fuselage labeled
RUDD. Secure the connection with a servo connector clip (SPMA3054, not included)
or wrap with tape. Feed the excess servo wire into the fuselage.
2. Insert the fronts of the vertical fi ns into the holes in the fuselage and rotate the
fi ns down until it they are fully seated on the fuselage.
3. Secure each fi n with two M3 x 16 mm fl athead screws through rear fi n braces,
as shown. Do not over tighten the screws.
Using SAFE
®
Select With the DX6 and DX6e Transmitters With a 6 Channel Aircraft
Model Assembly
