EN
Sukhoi SU-29MM
Model Assembly
Landing Gear Installation
1. Install the landing gear strut (
A
) as shown.
2. Install the U-cover (
B
) on the fuselage.
3. Install the fairings (
C
) on the strut.
4. Secure the landing gear assembly by using 4 screws (
D
).
Tip:
Carefully support the aircraft while installing or removing screws.
Disassemble in reverse order.
A
B
C
2 X 10mm (4)
D
Wing Installation
1. Slide the wing tube (
A
) into the fuselage.
CAUTION:
DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
2. Install the left and right wing (
B and C
) over the wing tube and into the
wing slot of the fuselage while inserting the aileron servo connectors
through the provided holes.
3. Invert the fuselage so the landing gear is facing up. Secure the left and
right wings to the fuselage using the included screws (
D
).
4. Remove the canopy (
E
) from the fuselage.
Tip:
If needed, use hemostats or pliers to pull the servo connectors into
the fuselage.
5. Connect the aileron servos from the wings to the Y-harness connectors in
the fuselage. The left and right aileron servos can be connected to either
side of the Y-harness.
6. Replace the canopy.
Disassemble in reverse order.
IMPORTANT:
Correct operation of the AS3X system requires connection of
both ailerons to the included Y-harness and the AILE channel of the receiver.
A
B
C
E
E
3 X 22mm (2)
D
6
