EN
Model Assembly
Continued
Horizontal Tail Installation
1. Slide the horizontal tail tube (
A
) into the hole in the rear of the fuselage.
2. Install the left and right horizontal tails (
B
) onto the fuselage as shown.
Ensure the control horn faces down.
3. Apply 4 pieces of tape (
C
) to the fuselage mounts (one on the top and
bottom of each half of the horizontal tail).
4. Attach the linkage (
D
) to the outermost hole in the elevator servo arm using
the link keeper (
E
).
5. Attach the ball link (
F
) to the elevator control horn using the included
nut (
G
) and screw (
H
).
6. Ensure the elevator servo arm is in the correct position, then adjust the
linkage to center the elevator.
When needed, disassemble in reverse order.
Control Surface Centering
After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the length of
the linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and
sub-trims to 0, then adjust the clevises to center the control surfaces.
B
A
C
D
E
F
H
G
• Turn the linkage clock-
wise or counterclockwise
until the control surface is
centered.
• Attach the linkage to the
servo arm or control horn
after adjustment.
7
