background image

EN

Commander mPd 1.4m

20

Contact Information

Country of Purchase

Horizon Hobby

Contact Information

Address

United States 

of America

Horizon Service Center (Repairs and Repair Requests)

servicecenter.horizonhobby.com/RequestForm/

2904 Research Rd

Champaign, Illinois, 61822 USA

Horizon Product Support (Product Technical Assistance)

[email protected]
877-504-0233

Sales

[email protected]
800-338-4639

European Union

Horizon Technischer Service

[email protected]

Hanskampring 9 

D 22885 Barsbüttel, Germany

Sales: Horizon Hobby GmbH

+49 (0) 4121 2655 100

FCC ID:BRWSPMSR6200A

Supplier’s Declaration of Conformity

 EFL  Commander mPd 1.4M BNF Basic and PNP (EFL14850/EFL14875)

This device complies with part 15 of the FCC Rules. Operation is subject to 

the following two conditions: (1) This device may not cause harmful 

interference, and (2) this device must accept any interference received, 

including interference that may cause undesired operation.

 CAUTION:

 Changes or modifications not expressly approved by the party 

responsible for compliance could void the user’s authority to operate the 

equipment.

NOTE:

 This equipment has been tested and found to comply with the limits for 

a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are 

designed to provide reasonable protection against harmful interference in a 

residential installation. This equipment generates, uses and can radiate radio 

frequency energy and, if not installed and used in accordance with the instructions, 

may cause harmful interference to radio communications. However, there is 

no guarantee that interference will not occur in a particular installation. If this 

equipment does cause harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, the user is encouraged to 

try to correct the interference by one or more of the following measures:

•  Reorient or relocate the receiving antenna.
•  Increase the separation between the equipment and receiver.
•  Connect the equipment into an outlet on a circuit different from that to which 

the receiver is connected.

•  Consult the dealer or an experienced radio/TV technician for help.

Horizon Hobby, LLC 

2904 Research Rd.,

Champaign, IL 61822

Email: [email protected]

Web: HorizonHobby.com

FCC Information

IC Information

IC: 6157A-SPMSR6200A

CAN ICES-3 (B)/NMB-3(B) 

This device contains license-exempt transmitter(s)/receivers(s) that comply with 

Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). 

Operation is subject to the following 2 conditions: 

1. This device may not cause interference.

2. This device must accept any interference, including interference that may 

cause undesired operation of the device.

the included items, and a brief summary of the problem. A copy of your original sales 

receipt must be included for warranty consideration. Be sure your name, address, and 

RMA number are clearly written on the outside of the shipping carton.

NOTICE: Do not ship LiPo batteries to Horizon. If you have any issue with 

a LiPo battery, please contact the appropriate Horizon Product Support 

office.

Warranty Requirements 

For Warranty consideration, you must include your original sales receipt verifying the 

proof-of-purchase date. Provided warranty conditions have been met, your Product 

will be serviced or replaced free of charge. Service or replacement decisions are at 

the sole discretion of Horizon.

Non-Warranty Service

Should your service not be covered by warranty, service will be completed and payment 

will be required without notification or estimate of the expense unless the expense 

exceeds 50% of the retail purchase cost. By submitting the item for service you are 

agreeing to payment of the service without notification. Service estimates are available 

upon request. You must include this request with your item submitted for service. Non-

warranty service estimates will be billed a minimum of ½ hour of labor. In addition you 

will be billed for return freight. Horizon accepts money orders and cashier’s checks, as 

well as Visa, MasterCard, American Express, and Discover cards. By submitting any item 

to Horizon for service, you are agreeing to Horizon’s Terms and Conditions found on our 

website http://www.horizonhobby.com/content/service-center_render-service-center.

ATTENTION:

 Horizon service is limited to Product compliant in the country of 

use and ownership. If received, a non-compliant Product will not be serviced. 

Further, the sender will be responsible for arranging return shipment of the 

un-serviced Product, through a carrier of the sender’s choice and at the sender’s 

expense. Horizon will hold non-compliant Product for a period of 60 days from 

notification, after which it will be discarded.

10/15

Содержание E-flite Commander mPd 1.4m























Отзывы: