EN
Commander mPd 1.4m
16
Motor Service
Control Surface
Replacement Servo
Description
Replacement Adhesive
Aileron
SPMSA332
9g Sub-Micro MG Servo
Deluxe Materials Foam 2 Foam (DLMAD34)
Elevator
Rudder
Flaps
Servo Service
A
C
G
B
H
F
E
D
Wiring not shown
L
K
CAUTION:
Always disconnect the flight battery before performing motor
service.
Disassembly
1. Remove the spinner screw (M3 x 30mm)
(A)
and the spinner
(B)
.
2. Use a tool to remove the spinner nut
(C)
, and then remove the
propeller
(D)
, spinner backplate
(E)
, hub (
F
), and collet
(G)
, from the
motor shaft.
3. Pull to remove the magnetically attached cowl (
H
) from the fuselage.
4. Remove the 4 screws (M3 x 35mm) (
I
) and the motor (
J
) with the
X-mount from the fuselage.
5. Disconnect the motor wires from the ESC wires.
6. Remove the 4 screws (M3 x 6mm)
(K)
and motor from the
X-mount (
L
).
Assembly
7. Assemble in reverse order.
• Correctly align and connect the motor wire colors with the ESC
wires.
• Install the propeller with the size numbers (12 x 6E) facing forward.
• Tighten the spinner nut to secure the propeller into place.
I
J
