Horizon Hobby Blade 350 QX BNF, Инструкция по эксплуатации

Страница: 5 / 20

5 EN
The Battery Charging Process
1. Charge only batteries that are cool to the touch and are not damaged. Look at the battery to make sure it is not damaged e.g., swollen, bent, broken or punctured.
2. Attach the input cord of the charger to an appropriate power supply, such as a 12V battery or 12V DC power supply.
3. When the Li-Po charger has been correctly powered up, there will be an approximate 3-second delay, then an audible “beep” and the green (ready) LED will fl ash.
4. Turn the control on the Amps selector so the arrow points to the charging rate required for the battery (the 2200mAh Li-Po battery will charge at 2.0 amps).
DO NOT change the charge rate once the battery begins charging.
5. Move the cell selector switch to 3-cell for your battery.
6. Connect the balancing lead of the battery to the 3-cell (4 pin) charger port and press the Start button to begin battery charging.
7. The green and red LEDs may fl ash during the charging process when the charger is balancing cells. Balancing prolongs the life of the battery.
8. When the battery is fully charged, a beep will sound for about 3 seconds and the green LED will shine continuously. Attempting to charge an over-discharged
battery will cause the charger to repeatedly fl ash and beep, indicating an error has occurred.
9. Always unplug the battery from the charger immediately upon completion of charging.
CAUTION: Overcharging a battery can cause a fi re.
NOTICE: If using a battery other than the included Li-Po battery, refer to your battery manufacturer’s instructions for charging.
IMPORTANT: Consult local laws and ordinances before installing and operating any type of photograph-capable or video recording device in this product.
Mounting a Camera
1
2
Installing the Included Camera Frame to the Isolation Mount
* Camera not included
*