Horizon Fitness Elite T5, Руководство по обслуживанию

Страница: 55 / 56

55
6.7 Running Belt Replacement-Cont.
How to adjust the running belt:
After placing the treadmill in position it will be used, the belt must be checked the proper tension and cen-
tering. The belt may need to adjusted after 2hrs of use. Temperature and humidity will cause the belt to
stretch at different rates. If the belt start to slip when a user on it, be sure to follow below directions:
Step1: Locate the two hex head bolt on rear of the treadmill .the bolts are located at each end of the
frame at the back of treadmill. These bolts adjust the rear roller.
Step2: There should be an equal amount of space on either side of running belt and side rails. If the belt
touch one side, turn the belt counter clockwise approximately one round on each side. Manually center
the belt by pushing the belt towards the center. Tighten the bolts the same round as they were loosened.
Step3: While the treadmill runs at 3mph,observe the belt position. If it is moving to the right, tighten the
right bolt by turning it clockwise 1/4 rounds, and then loosen the left the same rounds. If it moving to the
left, do the opposite. Repeat steps 3 until the belt remains centered several minutes.
Step4: Check the tension of belt. the belt should be very snug. When a person walks or run on the belt, it
should not hesitate or slip. if this occurs, tighten as steps 3.repeat it if necessary.
CHAPTER 6: Parts Replacement