Horizon Fitness 7.0AT-03, Руководство по обслуживанию

Страница: 37 / 48

P
ART
R
EPLACEMENT
Table of Contents
7.0AT-03
37 Service Manual
Running Belt Replacement
1. Remove the motor cover as outlined in Section above.
2. Remove the rear roller as outlined in Section above.
3. Remove the running deck as outlined in Section above.
4. Remove the front roller as outlined in Section above.
5. Remove the running belt.
6.
Reverse Steps 1-5 to install a new running belt.
7.
Use the silicone oil that was included with the machine to lubricate the belt and deck. If needed,
contact Customer Technical Support to purchase a new bottle of silicone oil.
Note1:
1.
Adjust running belt tension after replacement (Note2)
2.
The running deck uses silicone on one side . New deck surfaces must ALWAYS be matched to a
new running belt.
Note2:
ADJUSTING THE RUNNING BELT
After placing the treadmill in the position it will be used, the belt must be checked for proper
tension and centering. The belt may need to be adjusted after the first 2 hours of use.
Temperature, humidity, and use cause the belt to stretch at different rates. If the belt starts to
slip when a user is on it, be sure to follow the direction below.
Step1: Locate the two hex head bolt
s
on the rear of the treadmill. The bolts are located at each
end of the frame at the back of treadmill. These bolts adjust the rear roller. Do not adjust until
the treadmill is on. This will prevent over tightening of one side.
Step2: The belt should have equal distance on either side between the frames. If the belt is
touching one side, do not start the treadmill. Turn the bolts counter clockwise approximately one