Cable Wiring Diagram
□
Button
（Wiring: Yellow）
k
Button
（Wiring: Orange）
○
Button
（Wiring: Green）
R2 Button
（Wiring: Red）
L1 Button
（Wiring: Purple）
L2 Button
（Wiring: Black）
R1 Button
（Wiring: White）
Option Button
（Wiring: Gray）
The cable wiring is as shown in the diagram below.
If you do not know the mounting position of the quick disconnect blade connectors after
inserting and removing it, refer to the cable wiring diagram below.
- The diagram orientation shown is the inside when the housing cover is opened.
•
When installing a button, push the button in until
the stopper clicks into place.
2) As shown in the image to the right, push the two stoppers gradually
to remove the button.
- Parts may be damaged if too much force is used.
- Be careful not to cut your hands on the edges of the button holes on the housing cover.
- After installing, make sure that there is no gap between the button and housing cover.
Housing Cover
Stopper
①
①
②
• When installing a button, insert the blade connectors as far as it will go.
Refer to the cable wiring diagram below when wiring each button.
1) Remove the quick disconnect blade
connectors connected to each button.
How to Remove Buttons
- When removing the quick disconnect blade connectors,
remove while pressing the area shown in the diagram to the right.
When performing maintenance, please refer to the “How to Remove a Button” section and the
“Cable Wiring Diagram” as shown below.
Quick disconnect
blade connector
Push
△
Button
（Wiring: Blue）
