Assemble
Note:
The
white switch lock
above the ON/Off switch, aids
in
assembly
of your cleaner.
Assembly can be continued if the
switch lock is missing. However,
do not remove
the switch lock
until assembly is completed.
Align upper handfe and lower
handle as shown.
D
I
Place upper (C) and lower (D) handle parts on a fiat surface,
aligning rod sections
With hands on sides of parts, push
them together firmly until they “click” and rod sections lock
together.
*Be careful not to press against rod (B) extending from the
lower handle shown in Fig.-l-3. Do not push handle
together with hands on ends of handle parts.
Step 2
With side marked “UP” visible, insert
Rotate cord protector (E) on cord
rectangular end of cord into
until
see its arrow
With arrow on cord protector (E)
pocket in bottom of
toward arrow on upper
handle (G), press groove (H) in
Make sure rectangular end is
pushed down into the handle as far
cord protector into slot (I) in
upper handle.
as possible.
Slide cord protector (E) toward
upper handle.
Step 3 Attach handle
Press cord into place at each of the
three notches indicated.
Note location of tapered rails (J) on
bracket (K) and on lower handle.
Do not plug cleaner in until
assembly is totally complete.
With
printed
side of bracket (K)
facing up, slide rails on bracket
onto rails (J) on lower handle
until
bracket snaps past
the lock tab (L).
4
