Changing
Disconnect cleaner from electrical outlet.
Removing-bag door
Pull bag door latch forward and remove
door from cleaner.
Grasp bag collar and pull collar from tube.
Note: Do not clean
old bag and
reuse. Discard used bag.
and installing filter
Align opening in new filter bag with dirt
tube (B) inside bag compartment. Push
bag collar (A) firmly onto tube.
top of bag down under top of bag
compartment.
Replacing bag door
To replace bag door, lift up lower edge of
filter bag.
the 2 tabs (C) on bottom
of bag door into the 2 slots on bag
compartment.
sure all edges of filter bag are
inside the bag
Close door
(some models)
The final filter assists in the filtration process to return dean air to the room.
to clean
Removing filter
Disconnect cleaner from electrical
Lift out filter (A) and hand wash it in cold
water with mild detergent.
Removing door
Let filter air
dry
and reposition it on
To
remove this filter when it becomes
the front of the cleaner. Make sure
dirty, depress door latch and remove
the white
colored side of filter faces
door.
outward.
-Headlight
What to buy
This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover
part No. 27313-101
How to replace
Disconnect cleaner from electrical
outlet.
Removing hood
Using a Phillips head screwdriver,
remove the 4 hood screws (A) and lift off
carpet height control (B).
Lift hood off cleaner base just enough to
access the bulb.
10
Installing bulb and
ing hood
Pull old bulb straight out of socket.
Push new bulb straight into socket until
locked in place
Excessive force is not required.
Reposition door
Place tabs (B) on door into slot in lower
front of cleaner. Close door.
Should you want to replace this filter, ask
for HOOVER part No. 38766017.
Reposition hood, carpet adjustment
control and the 4 screws. Tighten
screws securely.
