Hoover HDB 642, Инструкция по эксплуатации

Страница: 5 / 21

“DELAY START button”
Appliance start time can be set with this button, delaying the start by 3, 6 or 9 hours.
Proceed as follows to set a delayed start:
Select a programme (“STOP” indicator light blinks)
Press "Delay Start" button (each time the button is pressed the start will be delayed by 3, 6
or 9 hours respectively and the corresponding light will blink).
Press "Start/Pause" to commence the Delay Start operation (the indicator light associated
with the selected Delay Start time stops blinking and remains ON).
At the end of the required time delay the programme will start.
To cancel the Delay Start function :
press the "Delay Start" button until the indicator lights will be off (The "STOP" light blinks)
and the programme can be started manually using the "Start/Pause" button or switch off the
appliance by turning the programme selector to "OFF" position.
D
Warning: If there is any break in the power supply while
the machine is operating, a special memory stores the
selected programme and, when the power is restored, it
continues where it left off.
8
TIME TO END indicator light
In order to manage your time better, this washing machine features an indicator light system
that keeps you constantly informed on the remaining cycle time.
Indicator light 90:
Remaining time above 60 minutes.
Indicator light 60:
Remaining time less than 60 minutes.
Indicator light 30:
Remaining time less than 30 minutes.
Indicator light 15:
Remaining time less than 15 minutes.
Indicator light STOP:
End of the programme.
E
“SPIN SELECTION” button
The spin cycle is very important to remove as much water as possible from the laundry without
damaging the fabrics. You can adjust the spin speed of the machine to suit your needs.
By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle
can be cancelled. To reactivate the spin cycle press the button until you reach the spin speed you
would like to set. To prevent damage to the fabrics, it is not possible to increase the speed over
that which is automatically suitable during the selection of the program.
It is possible to modify the spin speed without to pausing the machine.
Note:
The machine is fitted with a special electronic device, which prevents
the spin cycle should the load be unbalanced. This reduces the noise
and vibration in the machine and so prolongs the life of your machine.
F
9
Spin speed indicator light
When you set a program, the maximum possible spin speed will be automatically shown by
the relevant indicator light.
Choosing a smaller spin speed by the appropriate button, the relevant indicator light will go on.
G
“STAIN VANISH” Button
By pressing this button, which can only be activated in the Cotton cycles, the sensors in the
new system come into operation. They affect both the selected temperature, keeping it at a
constant level throughout the wash cycle, and the mechanical function of the drum.
The drum is made to turn at two different speeds at crucial moments. When the detergent
enters the garments, the drum rotates in such a way that the detergent is distributed in a
uniform manner; during the wash and rinse procedures, however, the speed increases in
order to maximise the cleaning action. Thanks to this special system, the efficiency of the
wash procedure is improved WITHOUT ANY INCREASE IN THE LENGTH OF THE
PROGRAM.
H
The option buttons should be selected before pressing
the "Start/Pause" button.