Dr. K. Hönle Medizintechnik GmbH
idromed
®
5 PS
G
EBRAUCHSANWEISUNG
9
Set the therapy
current!
Place your hands, feet or
armpit sponges
2
mA
Therapy time is
running!
Remaining time 9 min.
2
mA
If you feel a tingling sensation or burning, the current
intensity is too high and must be scaled down.
If you do not feel a tingling sensation or light cauterisation,
the current intensity have to be increased until a tingling
sensation or light cauterisation occurs and then have to be
decreased.
Regulate the current by turning the knob right or left until you feel
a soft tingling sensation at the armpits.
Repeat this process until the tingling sensation/burning ends or
until you feel it and then turn the knob a little back to the left.
When treating (15 minutes) the armpits, the sponge electrodes
have to be kept still and with constant pressure under the
armpits. Otherwise there will occur fluctuations of current at the
display of the unit or the unit can display a malfunction
information.
Take your hands,
feet or
armpit sponges out
Please
switch off
the machine!
If there is a break in treatment, the unit retains the remaining
treatment time.
At the end of the treatment remove the sponge electrodes from
the armpits.
Turn the knob to the switch setting (
●
) and switch off the unit by
pushing down the knob.
Always check the position of the turning knob. (Position
●
) immediately after
switching on the unit and the self-test completes.
3.
I
MPORTANT
T
IPS AND
I
NFORMATION
•
To simplify therapy the current intensity in mA for your treatment (pleasant tingling sensation –
aside from the treatment of the armpits) is displayed and can be set again consistently.
•
The maximum current and voltage are limited by safety limits prescribed for electrical medical
equipment. Nevertheless, do not remove your hand and/or feet from treatment tubs during the
session (keep the current circuit closed). Take care, that the unit is not switched off during
treatment.
•
The inhibition of sweating is much more pronounced at the positive pole than at the negative
pole. In order to optimize the therapeutic effect, you should therefore switch polarities before
every 5
th
treatment session. To do this, you have only to swap the electrode leads.
•
Please take care, that the water you are using is normal tap water and has not been treated
with a water softener before. That reduces the conductibility of water and treatment can be
make only conditional or none.
