VP527A Pneumatic
Water Valve
INSTALLATION INSTRUCTIONS
BEFORE INSTALLATION
AIR CONNECTION
Allow sufficient room for servicing or removing the valve. See
Fig. 1 for space requirements. This valve can be installed in
any position. The direction of the flow should be in the same
direction as the arrow cast on the valve body.
INSTALLATION
1.
Mount the valve. See Fig. 1 and 2.
2.
Connect the control air tubing.
NOTE: No calibration or adjustments are necessary.
1
2
2
2-1/4 (57) DIA.
FOR 1/4 IN. (6 MM)
O.D. PLASTIC TUBING
1-1/2
(38)
3-13/16
(97)
1-5/8
(41)
3-1/8 (79)
1-3/8
(35)
1/2 IN. (12MM) X 45
°
SAE FLARED TUBE
CONNECTION - 2 (NOT FURNISHED)
1
2
ALLOW 1-1/2 IN. (38 MM) MINIMUM CLEARANCE TO SERVICE VALVE,
2-1/2 IN. (63 MM) CLEARANCE TO CONNECT TUBING STRAIGHT TO
CONNECTOR. IF CLEARANCE IS LESS THAN 2-1/2 IN. (63 MM),
USE AN ELBOW CONNECTOR.
ALLOW 1-3/8 IN. (35 MM) MINIMUM CLEARANCE TO REMOVE VALVE.
M18348
Fig. 1. VP527A dimensions in in. (mm).
® U.S. Registered Trademark
Copyright © 2002 Honeywell • All Rights Reserved
95-5555EF