TG509, TG510, TG511, TG512 VERSAGUARD™ UNIVERSAL THERMOSTAT GUARDS
68-0104—4
9
Back-wired Thermostat (Fig. 11)
쐃
Place the thermostat on the wallplate template and
mark the mounting holes.
쐇
Locate the mounting holes on the guard wallplate using
the template as a guide.
쐋
Drill the required 5/32 in. mounting holes in the guard
wallplate.
NOTE:
If the mounting hole pattern on the guard
wallplate does not match the pattern on the
thermostat, drill additional mounting holes in
the guard wallplate.
쐏
Mount the smooth side of the guard wallplate facing the
thermostat and run the system wires through the wiring
hole in the guard wallplate. The guard wallplate must be
placed between the thermostat and the wall. See Fig. 11.
쐄
Back-wire the thermostat. Refer to the instructions
provided with the thermostat.
쐂
Mount the thermostat and the guard wallplate to the
wall using the 1-1/4 in. sheet metal screws provided
with the thermostat. Make sure the guard wallplate is
placed between the thermostat and the wall.
쐆
Place the thermostat cover on the thermostat.
쐊
Mount the guard ring base over the thermostat and the
guard wallplate.
쐎
Attach the ring base using four 1-1/4 in. sheet metal
screws or four anchors and screws (provided).
쐅
Mount the guard cover by placing the hinged edge of
the guard cover on the ring base and swinging it down
(horizontal mounting) or to the side (vertical mounting)
until the guard cover snaps into place against the ring
base. See Fig. 7.
쐈
Lock the thermostat guard by turning the key (provided)
counterclockwise. See Fig. 8. The key can be removed
only in the locked position.
쐉
Remove the paper backing and clear protective cover
from the included monogram and place the monogram
in the recessed area on the guard cover. See Fig. 9.
GUARD WALLPLATE
THERMOSTAT
BASE
THERMOSTAT COVER
M658A
80
70
60
50
WA
RM
CO
OL
CONNECT WIRES
TO TERMINALS ON
BACK OF THERMOSTAT BASE
WALL
RING BASE
MOUNTING
HOLES (4)
MOUNTING SCREWS (4)
Fig. 11. Mount guard wallplate and ring base on back-wired thermostat.
