Rev. D
69
KDMU000799
02/6/04
SECTION 9:
PROGRAMMING USING MAXPRO, PELCO P CODE, PELCO D CODE,
BURLE, OR VCL CONTROL SYSTEM
9.1 INTRODUCTION
This section provides information on any differences to the material provided for
standard protocol and provides information specific to operation with Maxpro,
Pelco P, Pelco D, Burle, or VCL control systems. Programming of the unit is the
same as described in
Section 7
, with the following statements. The section number
corresponds to the numbering in Section 7. Therefore, Section 9.6 provides
additional or replacement information to that in Section 7.6.
9.2 PROGRAMMING
PRESHOTS
No changes or supplemental instructions are required. Refer to
Section 7.2
.
9.3 PROGRAMMING
VECTORSCANS
No changes or supplemental instructions are required. Refer to
Section 7.3
.
9.4
PROGRAMMING SECTOR IDS
No changes or supplemental instructions are required. Refer to
Section 7.4
.
9.5
PROGRAMMING PRIVACY ZONES
No changes or supplemental instructions are required. Refer to
Section 7.5
.
9.6
PROGRAMMING PTZ TOURS
PreShots 83, 84, and 85
have been reserved for programming PTZ tours 1, 2, and 3.
1. Enter
a
PreShot 83
command on the system controller to program
PTZ tour 1
.
(Enter a PreShot 84 command for PTZ tour 2 or PreShot 85 command for
PTZ tour 3.)
2. During the 120 second countdown, pan and tilt the scan and adjust the lens zoom
setting. The scan scores the PTZ commands in the order they were performed
during the 120 seconds.
3. Wait for the countdown to reach 0 or send a
PreShot 86
command to end the
programming mode. The message “PTZ Tour Complete” is displayed. The scan
stores the PTZ commands in the order you entered them between the time you
started the programming mode until you entered the PreShot 86 command.
