Honeywell SmartLine STIW400, Руководство пользователя

Страница: 20 / 106

2. Preparation and Quick Start
2.3. Transmitter Quick Start
8 SmartLine Wireless Temperature and Universal I/O User's Manual Revision 1
5. VERIFY that the transmitter appears in the wireless network. This step may take several
minutes, depending on your network.
a. Drag the transmitter icon from the selection panel to the map (optional)
b. Load the DD file (if not done previously)
i. Select the transmitter.
ii. Press the maintenance “Templates” button.
iii. Press “Load DD File”, and select the DD .zip file.
iv. Refresh the browser to re-load the WDM web interface. This will require to
log in again.
c. Configure the transmitter as desired using the property panel
i. Tag Name, Description, Display Tag, Routing assignment, Publication
frequency, Publication attributes, etc.
ii. Ensure the press “Apply” after the changes, and wait for the changes to take
effect.
d. Configure the Channel types in the Transmitter

Channel Configuraiton panel. By
default, there are no installed channels on the transmitter. You must select one, two,
three, or four channels with the applicable sensor types.
i. Ensure the press “Apply” after the changes, and wait for the changes to take
effect.
e. Configure the channel(s) as desired using the Channel configuration property panels.
i. Sensor Type, Name, Description, Process limits, Process Scale, etc.
ii. Ensure to press “Apply” after the changes, and wait for the changes to take
effect.
f. Put the channel(s) into the desired operating mode. The default will be Out of
Service (OOS)
i. OOS, Manual, Auto, Normal.
6. INSTALL. If not done already, once the transmitter is verified to be functioning as expected,
it can be powered off and installed in the field. The provisioning key will remain.
7. CALIBRATE. If user calibration is required. See section 7.5