2
3
ASSEMBLY INSTRUCTIONS
A. Base Assembly
• Place base on a flat surface
• Fit bottom of Metal Fan Pole (A) into circular recess in fan base (Fig.2).
B. Securing the Fan Pole to the Base
• Align 3 screw holes at the base of Metal Fan Pole (A) with the 3 holes at the base.
• Secure the Metal Fan Pole to the base by inserting and tightening the 3 screws in
the 3 holes on the bottom of the base (Fig. 2).
• Slide the Pole Base Cover into place in the base and turn counterclockwise until it
snaps securely into place.
C. Determining the Height of the Fan
• Turn the Height Adjustment Knob (B) in a COUNTER-CLOCKWISE direction so that
the Knob loosens around the Metal Pole Extension.
• Pull the Metal Pole Extension out of the base to the desired height.
• Turn the Height Adjustment Knob (B) in a CLOCKWISE direction to tighten and
secure the Metal Pole Extension into place at the desired height.
Loosen
Fig. 3
B
Securing Knob
Tighten
Fig. 1
Fig. 2
Metal
Pole
Screws
A
Metal
Fan
Pole
A
Metal
Fan
Pole
D. Assembling the Upper Portion of the Fan
• Place the Motor Assembly (C) onto the Metal Pole Extension and secure it by
turning the Assembly Knob CLOCKWISE (Fig. 3).
Note:
If turning the assembly knob clockwise does not secure the motor assembly
to the metal pole extension, turn the assembly knob counter-clockwise until the
metal pole extension can slide further into the motor assembly. Then, turn the
assembly knob clockwise to secure it to the metal pole extension.
• Remove the Blade Knob (D) (turn CLOCKWISE) and Rear Grille Mounting Nut (E)
(turn COUNTER-CLOCKWISE) from the Motor Housing (Fig. 4).
• Place the Rear Grille onto the Motor Housing, making sure the 2 holes in the center
of the Rear Grille fit over the 2 raised knobs on the Motor Housing. Now place
the Rear Grille Mounting Nut (E) onto the center of the fan, and tighten by turning it
CLOCKWISE (Fig. 5).
• Push the Fan Blade onto the Motor Shaft. Be sure that the grooves in the Fan
blade align with the motor shaft pin. Now place the Blade Knob on the center
of the fan, and tighten by turning it COUNTER-CLOCKWISE (Fig. 6).
• Properly align the Front Grille with the Rear Grille (Fig. 7). To secure the Front Grille
onto the fan, raise the built-in clips around the Front Grille, and fasten these clips
onto the Rear Grille (Fig. 8).
Once aligned, secure the screw and nut together at the base of the grille
(for certain models).
ASSEMBLY INSTRUCTIONS (continued)
DS-1600/1606 Fig. 5
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
D
C
F
E
B
Height
Adjustment
Knob
Clips (G)
Blade Knob (D)
Front Grille
Screw
Fan Blade
Control
Panel
Rear Grille
Mounting
Nut (E)
Rear Grille (F)
Nut
Motor
Assembly (C)
Metal Pole
Extension
Height Adjustment
Knob (B)
Metal Fan Pole (A)
Base
Pole Base Cover
