ACS Manual —
P/N 15842:
N3
5/4/2022
23
Labeling Annunciators & Expanders
Installation, Configuration, and Programming
5.10 Labeling Annunciators & Expanders
Insert custom display labels (slide-in labels)
Remove the center pages of this manual. If using the custom user display labels, type the appropriate information on
the labels. Carefully cut out the labels; to ensure the best fit, cut directly along the dotted line surrounding each label.
Insert them into the annunciator by slipping them into the label slots on the back side of the annunciator face plate
(see Figure 5.15).
NOTIFIER’s Magni•Fire CD contains LabelEase—a program for customizing professional slide-in labels.
Apply adhesive label onto flush-mount dress plate
If mounting the annunciator onto a flush-mount dress plate, remove backing from the adhesive-
backed Annunciator Label and stick the label to the bottom of the dress plate as shown in Figure 5.16.
5.11 Connecting Annunciator Keyswitch and Phone Jack
After applying the appropriate label, mount keyswitch and/or phone jack to the dress
plate.
Plug the switch leads from the Annunciator Keyswitch into the keylock connector.
Connector location varies with annunciator model; see below.
Wire phone jack into telephone circuit as shown in Figure 5.17.
If annunciator is last jack on telephone circuit, a resistor is required on the phone jack
where shown. Resistor rating varies depending on your system configuration:
•
If using a VCM-4RK configured for telephone operation: 4.7K ohm.
•
If using a FCM-1, a XP5-C, a XPC-8 or XPIQ circuit: 47K ohm.
NOTE:
ACM-24AT, ACM-48A, and expanders provide a plastic protector sheet to insert with the slide-in
labels. Labels should be slightly narrower than the protector sheet to allow easier insertion.
NOTE:
A special-purpose label ships with the optional Annunciator Keyswitch and with
Annunciator Phone Jack. This label replaces the one shipped with the annunciator. It has
holes that align with the holes on the dress plate, providing a location to mount the devices.
Figure 5.15
Slide-in Labels
A
C
M
2
4
-l
a
b
e
ls
.w
m
f
Figure 5.16 Applying the
Adhesive Annunciator Label
a
b
f1
p
la
te
.w
m
f,
l
b
l1
5
8
2
4
.j
p
g
ACM-24AT,
ACM-48A
J2
ACM-16AT,
ACM-32A
J4
Telephone
Circuit
Red
Red
Blac
Blac
A
K
S
A
P
J
-
keylock connector
(see table at left)
resistor (for
last jack on
telephone
circuit)
Figure 5.17 Connecting Annunciator
Keyswitch and Phone Jack
(ACM-16AT shown)
ABF-1, back view
with both options wired
