Honeywell MPA1C1, Руководство по установке

Страница: 34 / 52

33
Commission the MPA1C1
Perform the following steps to install the MPA1C1 panel:
Step 1. Check all wiring.
Step 2. Apply power to the panel with PoE or external power
supply.
Step 3. Setup the device with the Device Utility App for network
settings, time settings, and the mode of operation -
• Access control device in MAXPRO Cloud
• Access control device in WIN-PAK
• Stand-alone web enabled Panel (Primary or Secondary).
Note: The App will ask to reset the MPA1C1 in order to activate the
Bluetooth. Press the reset button for 20 seconds to reset to factory
default configurations and activate the Bluetooth communication
for the commissioning application. The Bluetooth on the MPA1C1
will remain active for 30 minutes.
Step 4. After downloading the commissioning configuration to
the MPA1C1, the MPA1C1 will automatically restart.
Step 5. Check for the RUN LED for a successful power-up. If the
LED is blinking green slowly, the panel is powered up
successfully.
Note: If no configuration is downloaded to the MPA1C1, then the
MPA1C1 is automatically set up as a MAXPRO Cloud
enabled device.
Warning: Use a static strap whenever touching the
panel to ensure protection from
Electrostatic Discharge (ESD).
Improper wiring can cause damage to the MPA1C1 at
power-up and result in a loss of warranty.