U s e r I n s t r u c t i o n s - E n g l i s h
4
SYSTEM COMPATIBILTY
Miller TechLine Horizontal Lifeline Systems
are designed for use with Honeywell-approved
components. Substitution or replacement with
non-approved component combinations, sub-
systems, or both, may affect or interfere with
the safe function of each other and endanger
the compatibility within the system. This
incompatibility may affect the reliability and
safety of the total system.
SYSTEM FORCES
The TechLine HLL is equipped with an inline
shock absorber. In the event of a fall, the
shock absorber limits system forces.
CAPACITY
The maximum capacity of Miller TechLine
Systems is two (2) workers at 310 lbs
(140.6kg) each, including body weight,
Equipment must not be altered in any
way. Repairs must be performed only by
the manufacturer, or persons or entities
authorized in writing by the manufacturer.
Any product exhibiting deformities, unusual
wear, or deterioration must be immediately
discarded.
Any equipment subject to a fall must be
removed from service.
The authorized person/user shall have
a rescue plan and the means at hand to
implement it when using this equipment.
Never use fall protection equipment for
purposes other than those for which it was
designed. Fall protection equipment should
never be used for towing or hoisting.
Always check for obstructions below the work
area to make sure potential fall path is clear.
Allow adequate fall clearance below the work
surface.
Never remove product labels, which include
important warnings and information for the
authorized person/user.
2.2 System Warnings and Limitations
tools, and clothing, for the two-worker
system. Do not exceed this weight.
Capacity ratings assume the anchorage
or structure to which the horizontal
lifeline kit is installed meets the load
requirements.
LIFELINE
Do not use this system if the tensioner does
not lock onto the lifeline or if any component
in the system does not operate properly or
appears to be damaged.
Use only the lifeline provided.
The lifeline must be placed at or above
the back D-ring on the harness, unless the
VSHFL¿F7HFK/LQH6\VWHPLVDSSURYHGIRUXVH
below the D-ring, such as those designated
IRUURR¿QJDSSOLFDWLRQV
Connect to the O-rings on the lifeline only.
All warnings and instructions shall be
provided to authorized persons/users.
All authorized persons/users must
reference the regulations governing
occupational safety, as well as applicable
ANSI or CSA standards. Please refer
to product labeling for information on
VSHFL¿F26+$UHJXODWLRQVDQG$16,DQG
CSA standards met by product.
Proper precautions should always be taken to
remove any obstructions, debris, material, or
other recognized hazards from the work area
that could cause injuries or interfere with the
operation of the system.
All equipment must be inspected before
each use according to the manufacturer’s
instructions.
All equipment should be inspected by a
TXDOL¿HGSHUVRQRQDUHJXODUEDVLV
To minimize the potential for accidental
disengagement, a competent person must
ensure system compatibility.
2.0 General Requirements,
Warnings and Limitations
2.1 General Requirements
Содержание Miller Techline HLLR Series
Страница 1: ...I254 Rev D MFP9720128 22 April 2013 ...
