Honeywell Marathon, Руководство пользователя

Страница: 244 / 286

13 - 52
Code 93
Defaults =
• Disable Code 93
• L1 Parameter Default Value : 4
• L2 Parameter Default Value: 55
When enabled, Code 93 symbols will be scanned, decoded and transmitted.
Set this parameter by scanning either of the bar codes shown below.
Set Lengths for Code 93
Lengths for Code 93 may be set for:
• any length,
• one or two discrete lengths,
• or lengths within a specific range.
The length of a code refers to the number of characters, including check digits, the code contains.
See ASCII Character Equivalents (page 13-86).
One Discrete Length (Parameter L1)
This option decodes only those codes containing a selected length. For example, when you want to scan only Code 93
symbols containing 14 characters, scan the “Code 93 One Discrete Length” bar code and then “1” and “4” bar codes
using
Imager Keypad Number Symbols (page 13-84). Default = 4.
To begin setting one discrete length, scan this Code 93 One Discrete Length bar code:
Next, scan two numeric bar codes that correspond to the desired value. Single digit numbers must have a leading zero.
To correct an error or to change a selection, scan Cancel on the Imager Keypad Number Symbols page.
Two Discrete Lengths (Parameter L2)
This option decodes only those codes containing two selected lengths. For example, when you want to scan only Code
93 symbols containing 2 or 14 characters, scan the “Code 93 Two Discrete Lengths” bar code and then “0”, “2”, “1” and
“4” bar codes using
Imager Keypad Number Symbols (page 13-84). Default = 55.
To begin setting two discrete lengths, scan this Code 93 Two Discrete Lengths bar code:
Enable Code 93
* Disable Code 93