LP916A-C PNEUMATIC REMOTE BULB THERMOSTATS
5
95-5559
CAUTION
Be careful not to change position of control shaft
when removing shipping stop and attaching setpoint
knob and scale plate to Thermostat.
B
Mount Thermostat from rear of panel and secure on
front with scale plate and screws (Fig. 14).
Fig. 14. Installing setpoint knob and scale plate.
C
Place setpoint knob on control shaft (Fig. 14) with
pointer aligned over mid-mark on scale plate.
Secure knob firmly with set screw furnished to
maintain calibration.
D
Mount sensing bulb in unit as required.
Bracket Mounting
The LP916 Mounting Kit Model is installed in terminal units
similar to Figure 5 or 6 using a 306016A or B Bag Assembly.
These assemblies include a mounting bracket, screws, nuts,
clips, bulb hangers, scale plate, and knob. The two bag
assemblies are similar except for the length of the mounting
bracket and the centers of the bracket mounting holes (Fig. 15
and 16). The two sets of holes in the mounting bracket allow
the Thermostat to be mounted either vertically or horizontally.
Fig. 15. Mounting bracket in 316016A bag assembly.
Dimensions in inches (millimeters).
C4648
2-3/4 (70)
5/8
(16)
1-7/8 (48)
3-1/4
(83)
BRANCH
MAIN
CAPILLARY
PROTECTED BARBS
THERMOSTAT
CONTROL SHAFT
SCALEPLATE
10-32 x 1/4-IN.
SCREW (2)
SETPOINT KNOB
SENSING
BULB
C4652