HW7000E/HW7000EL Portable Electrical Generator Owner’s Manual
www.honeywellgenerators.com
9
Assembly
Step 3: Install Handle Assembly
1.
Hold handle bracket over pre-drilled holes on frame
as shown in Figure 11.
2.
Attach bracket to frame using 40 mm long full-thread
hex flange bolts and serrated flange nuts and tighten.
3.
Slide rubber handle grip onto each handle bar and tap
on hard surface until fully seated.
4.
Slide handle bar through center of each bracket and
line up bolt holes.
5.
Attach handle to each bracket using 40 mm long full-
thread hex flange bolt and serrated flange nut to hole
closest to frame and tighten.
NOTE:
Handle should be in a horizontal position after tightening
bolts and nuts. If handle seems to hang down, tighten
bolts and nuts further.
6.
Attach pin to chain.
7.
Attach chain to handle bracket as illustrated below.
Insert pin through bracket and handle.
Once properly installed, the handles can be collapsed, if
desired, by removing the pins.
•
To collapse handles
, remove pins and push firmly
down on handle until it rests vertically against genera-
tor frame.
•
To return handles to horizontal position
, pull up on
handle and lock with pins.
To install handle assembly, you will need:
Handle brackets (2)
Handle bars (2)
Pins (2)
Chains (2)
Rubber handle grips (2)
M8 x 40 mm long full-thread hex flange bolts (6)
M10 serrated flange nuts (6)
Socket wrench with 10 mm socket
*
*
Not included
8 mm open end wrench†
FIGURE 11:
Handle Bracket to Frame
FIGURE 12:
Attach Grips to Handle
FIGURE 13:
Insert Handle Bar to Bracket
FIGURE 14:
Attach Pin and Chain
FIGURE 15:
Attach Chain to Handle Bracket
Hands and fingers can be pinched from collapsible
handles.
• Keep hands and fingers clear from hinges when
collapsing generator handles.
• Handles should only be used to roll the generator to a
new location. If lifting the generator (i.e. into a vehicle),
never use the handles to support the complete weight
of the generator.
CAUTION
Содержание HW7000E
Страница 99: ... ...
