Honeywell HE0118, Руководство по установке

Страница: 7 / 11

1
Bind Zone-1 Thermostat to Zone-1 Zone Valve Controller (BDR91)
3
5 6 4
1 2 Put BDR91 into BIND mode
by pressing the button
again for 5 seconds (until
the red LED blinks slowly).
Send BIND signal by
pressing the BIND
button again.
The red LED on the BDR91
will stop blinking and go off.
Put Thermostat into BIND
mode by pressing below
and left of display for 10
seconds (until a flashing
‘bo’ is displayed).
Install and power BDR91
Zone Valve Controller (see
BDR91 instructions).
Press and hold the button
for 15 seconds (until the red
LED blinks rapidly) to clear
any stored binding data.
Press
Once
Press
10sec
Press
15sec
Press
5sec
Repeat this process for binding Zone-2
Thermostat to Zone-2 Zone Valve Controller
7
Thermostat will display binding confirmation
+ signal strength (5 = good signal) for a few
seconds before returning to normal operation.
few
secs
5 21
.5
Continue to step
3
on the next page...
2
Connect Remote Access Gateway to power
LED Status