Honeywell Granit XP 199 i Series, Руководство пользователя

Страница: 137 / 312

Granit XP User Guide 119
To remove this delay, scan the Intercharacter Delay barcode, then set the number
of delays to 0. Scan the Save barcode from the Programming Chart, beginning on
page 291.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be
placed after the transmission of a particular character of scanned data. Scan the
Delay Length barcode below, then scan the number of 5ms delays from the
Programming Chart, beginning on page 291, then Save .
Next, scan the Character to Trigger Delay barcode, then the 2-digit hex value for a
printable character to trigger the delay (see Lower ASCII Reference Table , page
283.
)
To remove this delay, scan the Delay Length barcode, and set the number of
delays to 0 . Scan the Save barcode from the Programming Chart, beginning on
page 291.
Interfunction Delay
An interfunction delay of up to 5000 milliseconds (in 5ms increments) may be
placed between the transmission of each control character in the message string.
Scan the
Interfunction Delay barcode below, then scan the number of 5ms delays,
and the Save barcode from the Programming Chart, beginning on page 291.
Delay Length
Character to Trigger Delay
Interfunction Delays
Prefix Scanned Data Suffix
1 2 3 4 5 STX HT CR LF
Interfunction Delay