Honeywell FF-LS082802362, Руководство по установке

Страница: 12 / 46

107022-16 EN FR26 GLO 301 Printed in Germany
12
Figure 2-3 Sensing units (A and B) rating and approval plate
16
FLS35.EPS
Figure 2-4 Control unit warning plate
2.2.4. Specifications
OPERATING CHARACTERISTICS
Resolution (minimum object detection) 14 mm (0.55 in) or 30 mm (1.18 in) diameter
Response Time < 50 ms
Restart time < 300 ms
Scanning Range 0,2 m to 3,5 m (0.65 ft to 11.48 ft)
Emission Modulated infrared light (880 nm)
Alignment tolerance According to IEC/EN 61496 - 2 standard
ELECTRICAL CHARACTERISTICS
Supply voltage 22 to 30 Vdc or 18 to 25 Vac
Current consumption < 300 mA
Output switching capacity 2 NO safety outputs (MAIN OUT 1 and MAIN OUT 2): 4 A/250 Vac positive-
guided (fuse protected)
Lamp indicator: 1 NO, 1 NC outputs, 4 A/42 Vac (fuse protected)
Electrical connection Control unit: screw terminal
Sensing units: RS-485 cable; pre-wired connectors; 10 m (32.8 ft)
ENVIRONMENTAL/PHYSICAL CHARACTERISTICS
Sealing Control and Sensing Units: IP 65, NEMA 4
Electromagnetic immunity According to IEC 801-4: level IV
According to IEC 801-3: level III
Light immunity 50 000 lux
Status indicators Customer supplied lamps must be connected to the indicator outputs of the
control unit.
Operating temperature 0°C to 55°C (32°F to 131°F)
Material Sensor Units: Aluminum
Control Unit: Polycarbonate
Size 30 mm Resolution Sensor Units: 12 x 19,7 x Nominal Protected Height (mm)
0.47 x 0.77 x Nominal Protected Height (in)
14 mm Resolution Sensor Units: 23 x 35 x Nominal Protected Height (mm)
0.90 x 1.38 x Nominal Protected Height (in)
Control Unit: 60 x 160 x 240 (mm)
2.36 x 6.30 x 9.45 (in)
2.3. Operation
The FF-LS Series are through scan safety light curtains. Emitter circuitry (sensing unit A and B) transmits modulated,
infrared light that is detected by photoreceiver circuitry (sensing unit A and B). The number of light beams depends on the
protected height and resolution of the safety light curtain.
Red label indicates the
number of beams. This
number must be the same
number that is on the
control unit’s red label.