-
7
-
Step
Action
Display
3.
To change any of the programming for the wireless key, perform one
of the following steps in the
Programming for an Installation WITH
Local Wireless Keys
section
.
•
For the user code, perform step 5.
•
For the loop functions, perform steps 6 and 7.
•
For the on-board relay assignment, perform steps 8 to 10.
Alternately flashes "d*" with the device number;
and “--.”
4.
When you have completed editing the wireless keys, press the [
✻
] key
twice to exit the Program mode
.
* The keypad will display the last number that was enrolled (i.e., “d3”)
Note:
Upon exiting the Program mode, the 6150RF alternately flashes "Ad," the 2-digit keypad address, and the 2-digit receiver
address. If either of these is incorrect, repeat steps 1 through 3 in the
Programming for an Installation Without Local Wireless
Keys
section
.
TROUBLESHOOTING
The following error messages cause the 6150RF to produce rapid beeps for 5 seconds. The table below describes the
error messages and the corrective actions.
Display
Probable Cause
Corrective Action
Lb
Low battery in the wireless
key
1.
Replace the battery if the wireless key has a replaceable battery.
2.
Replace the transmitter if the wireless key does not have a replaceable
battery.
OC
Open circuit
Verify that the Data Out wire is connected properly.
1C
Incompatible connection
Verify that the control panel is not a First Alert-type control panel.
Check 09 OR
Check 100 RF
Receiver OR
Check 10n RF
Receiver*
1.
6150RF Receiver is not
communicating
2.
Another device on the
keypad terminals is not
communicating to the
control panel
1.
Verify that the Data In wire is connected properly.
2.
Verify the wiring connections between the control and all other devices.
E8
Too many RF zones
programmed
Verify the number of transmitters programmed into the control panel
*n = receiver address programmed in VISTA control panel
SPECIFICATIONS
Physical:
6-1/4” H x 4-7/8” W x 1” D
(158.75mm x 123.8mm x 25.4mm)
Wiring:
Refer to Wiring Table on page 2
Range:
200' nominal
Frequency:
345 MHz
Voltage:
12VDC
Current:
Standby 80mA
Backlighting on and
Sounder
on
105mA
Relay:
Normally-Open, 1A, 28VDC
Sounder:
Piezo-electric (fire alarm is loud pulsing tone;
burglary/audible panic alarm is two tone
sound
FOR DETAILS ON THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM, REFER TO THE INSTALLATION INSTRUCTIONS
FOR THE CONTROL PANEL WITH WHICH THIS DEVICE IS USED.
