5
STANDARD OR ANGLE MOUNT INSTRUCTIONS
1. Remove the downrod pin and downrod clip from the downrod. Then, loosen but don’t remove the two set screws in the yoke
(Figure 3.1).
2. Feed the fan wires through the yoke cover, canopy and downrod (Figure 3.2).
3. Slide the downrod into the yoke of the motor assembly. Align holes and reinstall the downrod pin and downrod clip and secure
with the set screws (Figure 3.3).
4. Depending on the length of downrod you use, you may want to cut the fan wires to simplify wiring. After pulling the wires all
the way through the downrod, measure 8 inches of wire. Cut off the excess wire using wire cutters (not included). Then strip
1/2 inch of insulation from the end of each wire strand (Figure 3.4).
5. Install the ball end of the downrod into the opening of the mounting bracket.
WARNING:
Failure to align the slot in the ball
with the tap on the mounting bracket may cause the fan to fall, which could result in injury or death. Then, insert the receiver
into the opening of the mounting bracket with flat side facing up (Figure 3.5).
Skip to FINAL INSTALLATION, page 6.
8 in.
Figure 3.1
Figure 3.5
Downrod Clip
Downrod
Canopy
Yoke Cover
Yoke
Mounting
Bracket
Downrod
Downrod
Receiver
Downrod
Downrod Clip
Downrod
Pin
Set Screw
Downrod Pin
Set Screw
Tab
Slot
Figure 3.2
Figure 3.3
Figure 3.4
