INNCOM E7 THERMOSTAT USER GUIDE
36-00013—02
18
e7 Commissioning/Room Function Tests
The e7 Thermostat is an energy management solution typically deployed in one of the following scenarios:
Digital Thermostat with EMS
- A programmable DDC thermostat designed for in-room energy
management that typically requires a wired or wireless door switch monitor and a motion sensor for
non-networked in-room energy management.
Digital Thermostat with Centrally Controlled EMS
- A programmable DDC thermostat designed for
in-room energy management that typically requires a wired or wireless door switch monitor and
motion sensor. The thermostat is wired or wireless networked to a server which monitors the system
through the use of INNCOM's INNControl 3 Supervisor software.
Digital Thermostat with Centrally Controlled EMS + Complex Applications
- In addition to the
above Centrally Controlled EMS application, the e7 can be augmented with a full range of guest
amenities, lighting control, drapery control, Central Electronic Lock Interfaces (CELS), and other
third party integrations.
IMPORTANT:
It is strongly recommended the following tests are conducted during commissioning the e7 to
ensure proper operation and connectivity to the system is achieved.
ENTER SERVICE MODE
Some of the following tests require entering the e7 SERVICE MODE. To enter SERVICE MODE, complete these
steps:
1.
Press and hold
o
F|
o
C.
2.
Press and hold MODE.
3.
Press and hold FAN.
4.
Release the three buttons.
PIR MOTION SENSOR TEST
1.
Enter SERVICE MODE.
2.
Use the UP/DOWN arrow buttons to select
PIr
.
3.
Press MODE to begin the test. The unit
beeps
as it detects motion and the
display shows a count of the number of motion pulses detected.
If there is no audible beep, then the on-board motion sensor is faulty. Con-
tact Honeywell for a replacement e7 thermostat.
4.
Press
o
F|
o
C twice to exit service mode.
DOOR SENSOR TEST
1.
Enter SERVICE MODE.
2.
Use the UP/DOWN arrow buttons to select
dor
.
3.
Press MODE to begin the test. When the door switch opens (door is open),
the e7 emits an audible beep and the display shows a count of the number
of times the door status changes from closed to open.
If there is no audible beep, then double check the door sensor wiring.
4.
Press
o
F|
o
C twice to exit service mode.
