Dalian Huarui Heavy Industry CNC Equipment Co.,Ltd.
21
· Kerf
Set the cutting kerf value of drawing for accountting the drwging size . Carfully use the cutting
kerf value because it will caused of the invalid working. It is possible to look at the cutting kerf by
using the spare part item after setting cutting kerf.
4.4
Cutting Type
Enter into CUTTING TYPE by pressing F2 under setting interface.
· Oxygen fuel
4-5 Set the oxygen-fuel cutting type
There are oxygen-gas control logic inside Controller. Set the cutting control logic ofdifferent
material by using following parameters. The Sequence Diagram will change by becoming
parameters.
Remark
:
Press key F9
(
start
)
twice, then key will jump over all setting time and start to cut
directly.